When the television is powered on for the first
time, it automatically checks for the presence of
an RF signal.
•
Press the POWER key to turn on the
DTV.
•
Then press the CHANNEL UP
(CH ) key to automatically
search for available channels:
Digital (ATSC) and Analog (NTSC).
The All Channel Search contains two processes that are
executed simultaneously for digital and analog channels.
NOTES: Channel information found during All Channel Search is
stored in two Channel Scan Memory databases
(Analog and Digital). After all channel search is com-
pleted, the TV will tune to the lowest Digital channel or
lowest Analog channel if no digital channels are found.
If the TV does not detect any digital or analog channels,
a message advising the viewer to check the cables and
antenna connections will appear. In this case, you
must press
the
CHANNEL UP key again to repeat the
channel search process. If after two searches the TV
still fails to detect any channels, the TV will tune to
analog channel 3.
If no analog or digital channels are found after the
second search, All Channel Search will default to off-
air analog channels 2 through 69 and digital channel
D3-1. Select analog channels using the remote control
keypad. See page 16, item number 2.
4
ALL CHANNEL SEARCH
IMPORTANT NOTE: Spent or dis-
charged batteries must be recycled or
disposed of properly in compliance
with all applicable laws. For detailed
information, contact your local County
Solid Waste Authority.
2
INSTALL BATTERIES
•
Install two “AAA” Batteries (not included) so that the
“+” and “–” marks on the batteries match the “+” and
“–” marks inside the Remote.
To review the remote control functions, go to
pages 16 ~17.
NOTE: Use two “AAA” Alkaline batteries.
3
CONNECT AC POWER CORD
•
Connect AC Power Cord (supplied) to the Plasma TV
and electrical outlet as shown here.
The AC outlet must be near this equipment and must be
easily accessible.
To POWER CORD
CONNECTOR on back
of Plasma TV.
To 120 V AC outlet.
5
ANTENNA SIGNAL SELECTION
(OPTIONAL)
To change the initial
analog tuning system
setup (from antenna to
cable or cable to
antenna), use the on-
screen menu. See
“Analog Antenna Sig-
nal” on page 20.
8
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
FIRST-THINGS-FIRST (Required Initial Setup)
SKIP THE CHANNEL SEARCH PROCESS
Use this feature
only
if the DTV is used primarily for
playing video games, or watching videos, or if you receive
local channels from a satellite receiver or cable system.
•
Press the EXIT key to cancel the channel search
process.
•
The DTV will be tuned to Analog Channel 3.
•
Press the INPUT key (remote control) to select
AV signal source connected to: Video 1, Video 2,
Video 3, or HDMI jacks.
To Next Page
Loading...
