USING THE REMOTE CONTROL
PRECAUTIONS
To ensure safe operation, please observe the follow-
ing precautions:
Use (2) AAA alkaline batteries, see page 8.
Replace both batteries at the same time. Do not use a
new battery with a used battery.
Risk of explosion, if battery is replaced by an incorrect
type.
If batteries have leaked in the Remote Control Unit,
carefully wipe the case clean and load new batteries.
Do not expose the Remote Control Unit to moisture,
or heat.
REMOTE CONTROL KEYS
Input Key—Press to change the input signal source
as follows: Analog RF Digital RF Video 1
Video 2 Video 3 HDMI Analog RF.
Number Key—Two keys must be pressed to select a
direct channel.
Example:
Press 0 then 6 to select
channel 6.
For Analog Cable channels above 100, press and
hold the 1 key until C1– – appears, then press the
other two numbers.
Info Key—Press to display the Digital and Analog Full
Banner information (press again to remove the
display).
Digital Full Banner display—
Contains a two-part
Channel Number (Major and Minor) and Tuner ID. If
available the following is also included: Station ID,
Program Title, V-Guide Program Rating, Audio Info, and
Signal Strength.
Analog Full Banner display—
Contains the Channel
Number (analog antenna/cable), Tuner ID, Station ID (if
available), Program Title (if available), V-Chip Program
Rating, and Audio Info.
Program Title
Program Rating
Audio Info
Program RatingChannel No.
Station ID
Channel
Major Minor
Audio Info
Tuner ID
Tuner ID
Program Title
12
13
14
11
16
15
17
18
Point toward
DTV
16
Need help?
Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032
Station ID
Signal Strength
To Next Page
Loading...
