EasyManuals Logo

Sanyo LCD-40XR10F User Manual

Sanyo LCD-40XR10F
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
First Time Configuration/Basic Operations
Turning on your TV for the first time
Make sure that you have inserted the batteries in the
remote control, have connected your antenna to the
TV, and have connected the AC power.
Press the Power Switch on the TV.
Press POWER to turn on the TV. After a few
seconds the Energy Save Mode screen opens.
Press 3or4 to select Standard/Energy Save or
Store/Dynamic, press OK to confirm. (For normal
home use, please select Standard/Energy Save.)
Now the Installation Guide screen appears with
Channel Tuning highlighted. Press OK to begin the
auto tuning for all available ATV/DTV channels. It may
take several minutes, please wait until it is finished.
During searching, the screen will display a report
about found stations.
When complete, it will go to digital programme
position one. Now channel list has been created and
you can start to watch TV.
1
2
3
The first time you use the TV, you need to configure
your TV:
Installation Guide
OSD Language
English
Channel Tuning
Select
To use this TV for displaying in a store, please select [Store/Dynamic].
[Standard/Energy Save] mode is recommended for normal home use.
Energy Save Mode
Store/Dynamic
Standard/Energy Save
OK
OK
Exit
Exit
To configure your TV:
4
5
Turning the TV on or off
14
Power Switch
Channel Tuning
2 %...
ATV
ATV
DTV
Radio
Press <Menu> to skip.
Press <Exit> to exit.
: 2
Programme(s)
: 0
: 0
Programme(s)
Programme(s)
78.50MHz
OK
Start
Note: If the TV does not receive a broadcast signal for several minutes, the TV goes into
standby mode.
To turn the TV on or off:
Plug the power cord into an AC power outlet. Press Power Switch on the TV.
Now the set is in standby mode. Wait some seconds until the power indicator lights
up, then press POWER to turn on the TV. (Be sure to wait some seconds before
pressing POWER button. If you promptly press POWER button then the TV may not
respond or act wrongly.)
Press button again to turn off the TV and put the TV in standby mode.
To cut off the power completely, press Power Switch on the TV.
Warning: When the TV is in standby mode, power is still flowing into the TV. For the sake of
energy saving and safety issue, please press Power Switch to completely cut off the power.
After you turn off the TV, you should wait at least 5 seconds (the power indicator goes
out)before you turn it on again.
1
2
3

Other manuals for Sanyo LCD-40XR10F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo LCD-40XR10F and is the answer not in the manual?

Sanyo LCD-40XR10F Specifications

General IconGeneral
BrandSanyo
ModelLCD-40XR10F
CategoryLCD TV
LanguageEnglish

Related product manuals