Supports up to 10-bit dual LVDS full-HD (1920 x 1080) panel interface
Supports 2 data output formats: Thine & TI data mappings
Compatible with TIA/EIA
With 6/8 bits optional dithered output
Spread spectrum output frequency for EMI suppression
CVBS Video Output
Supports two CVBS bypass output ports
2D Graphics Engine
Point draw, line draw, rectangle draw/fill and text draw
BitBlt and stretch BitBlt
Raster Operation (ROP)
Miscellaneous
DRAM controller to support up to 32-bit DDR2 interface
Supports Common Interface for conditional access
SPI bus for external flash
Two ports of USB 2.0 host controller with the flexibility for connecting external storage
devices
375-ball LFBGA package
Operating at 1.26V (core), 1.9V (DDR2), and 3.3V (I/O and analog)
2、 Digital demodulating chip CE6353
The chip comprises 8MHz bandwidth SAW and supports demodulation of 6MHz,
7MHz and 8MHz, 2K/8K carrier and supports both serial and parallel TS stream
output.
3、 Audio power amplifier RENESAS R2A15112
R2A15112FP is a Digital Power Amplifier IC developed for TV.
R2A15112FP has a maximum power of 15W(typ) × 2ch.
(VD = 24V,THD = 1%, SE) at a 4 Ω load.
It is possible to replace a conventional analog amplifier
with a digital amplifier easily.
●Maximum power out put (No external heat sink)
(note) These apply when the thermal pad is soldered to
the printed-circuit board directly.
Recommended Power Condition
SE operation mode :15Wx2ch(VD=24V,4Ω load,THD+N:1%）
BTL operation mode:30Wx1ch(VD=21V,8Ω load,THD+N:10%）
●Highly efficient, low noise, and low distortion
●Popless
●Built-in protection - Overcurrent, overheat, and undervoltage
●Built-in Mute and Standby function
●The gain can be changed to four settings by two terminals.
To Next Page
Loading...
