Normal burning process is described as follows:
First, the step “Erasing…， Flash Status: 03” will last for some time, or it is failed if it is passed by
quickly, please confirm procedure 2）and begin burning process again; then the following step is
“Programming…，Flash Status:00”; at last, a prompt “Pass” will display.
7） A prompt “Pass” will display beside button “Run” if burning process is successful, please refer to
Fig. 6;
Fig. 6 A prompt “Pass” displaying beside button “Run” for successful burning process
8） If there are other machines to be burned, remain ISP burning interface and repeat procedures
3）and 5）only;
Note 3: Method of online burning and upgrade through USB:
1） Make sure that U disk is formatted as “FAT32”;
2） Copy firmware “Merge.bin” to U disk;
3） Power on TV set, be sure to be in channel of ATV or DTV and have not any OSD interface, insert
U disk into USB port of TV set;
a) First press key “SOURCE”, then press keys “2, 5, 8, 0” in turn to enter into initial factory
menu;
b) Select item “software update” to begin upgrade;
4） Upgrade process:
A、Read data from U disk, while data indicator light of U disk is twinkling at the same time;
B、Begin to burn Flash，the unit will be in “standby” mode after burning process completed;
5） Please restart the unit after power-off of hardware, then enter into factory menu, confirm software
parameters - version and time, execute item “RESET ALL” to complete the whole process.
*** USB burning method could not be sure to all kinds of U disks, so please try another U disk if one is
inapplicable.
To Next Page
Loading...
