29
Basic Operation
Information
Information display can be used to confirm the current
operating condition of the projector and the signal being
projected through the projector.
Press the INFORMATION button to display the
information window on the screen. Press the Point d
button or the INFORMATION button again to display the
next page. To hide the information window, press the
INFORMATION button again or Point 7 8 buttons.
The information window can also be selected from the
menu.
Information Menu
Information Menu
Press the Point ed buttons
to display the next or previous
page.
✔Note:
• The H- and V-sync freq. values described in this figure
may be different from the actual values.
•
SERIAL NO. is used to service the projector.
• When the lamp life reaches a recommended lamp
replacement time, the time shown in Lamp1 or Lamp2
turns red.
To Next Page
Loading...
