Message
POWER-LED
(Blue) (Red)
Standby (Input power cable)
Normal (Power on)
Powering up (Warming up) Flashing(1 sec)
Power off (Cooling-I: It can’t ac-
cept any key at this status)
Flashing(0.5 sec)
Power off (Cooling-II: It can
accept power key to turn on the
projector)
Flashing(1 sec)
Error (Lamp failed) Flashing(0.5 sec)
Error (Fan lock) Flashing(1 sec)
Error (Over temp.)
Flashing
(0.5 sec on, 2 secs off)
not turn on until the lamp module has been replaced. To replace
the lamp, follow the procedures in the “Replacing the Lamp”.
Problem: LED lighting message
Steady light =>
No light =>
To Next Page
Loading...
