Steady light =>
No light =>
*=> When LED light
on after 5 sec., go to
standby mode.
Message
POWER-LED
TEMP-
LED
LAMP-
LED
(Red) (Green) (Orange) (Red) (Red)
Standby (Input power cable)
Normal (Power on)
Powering up (Warming up) Flashing
Power off (Cooling-I: It can’t accept any
key at this status)
Flashing
Power off (Cooling-II: It can accept
power key to turn on the projector)
Flashing
Error (Lamp failed)
*
Error (Fan lock) Flashing
Error (Over temp.)
Problem: LED lighting message
To Next Page
Loading...
