Sanyo PDG-DXL2000 - Page 14

-14-
Mechanical Disassembly
1. Loosen 2 screws A and pull the Lamp assy upward off.
2. Remove 1 screw B(M2.5x6) to remove Temp. Sensor 2 board.
3. Remove 1 screw C(T3x12)x2 and 2 screws D (M4x8) to remove the Optical Unit upward
off.
Fig.2
x Optical unit Lamp and CW removal
A
B
D
D
C
(M2x8)x2
(M2x6)x2
(M2x8)x1
(M2x8)x3
(M2x6)x2
CW Sensor
board
Color Wheel
Color Wheel
assy
Optical unit
Temp Sensor 2
board
Lamp assy
Bushes