Sanyo PDG-DXL2000 - Circuit Adjustments

-23-
Adjustments
Circuit Adjustments
CAUTION: The each circuit has been made by the fine adjustment at factory. Do not attempt to adjust the following
adjustments except requiring the readjustments in servicing otherwise it may cause loss of performance
and product safety. Before adjustment, please turn on the projector more than ten minutes.
WARNING : USE UV RADIATION EYE AND SKIN
PROTECTION DURING SERVICING.
CAUTION:
To prevent suffer of UV radiation, those adjust
-
ments must be completed within 25 minutes.
[Adjustment Condition]
l Input signal
Analog Computer signal ..... 0.7Vp-p/75W terminated (XGA)
Composite Video signal .... 1.0Vp-p/75W terminated (NTSC / PAL)
Component Video signal .... 0.7Vp-p/75W terminated (480i)
l Input signal patterns
l Image mode ........................ Standard
l Lamp control ....................... Normal
l 3D mode ............................ Off
Note:
* Please refer to “Service Adjustment Menu Operation” for entering the service mode and adjusting the service data.
White 100%
Black 100%
16 steps gray scale pattern
8 color 100% color bar
W
Y C
G
M
R
B
BLK
White 100%
Black 100%
BK-W
BK-R
BK-G
BK-B
RGBW Ramp pattern
(Internal signal)