Sanyo PDG-DXT10KL - Resetting the Lamp Time Counter; Ordering a Replacement Lamp

6. Maintenance
101
Resetting the Lamp Time Counter
After replacing the lamp(s), the lamp hour counter(s) should be reset to zero. Refer to the following guide:
1.
Press the Menu button on the OSD
control panel or Remote Control to
open the Main menu.
2.
Press the Ÿorź button to move to
the Reset menu and press Select.
3.
The Reset menu is displayed. Se-
lect Clear lamp1 time or Clear
lamp2 time as required using
Ÿorź and press Select.
4.
A confirmation box is displayed.
Select OK using Ż or Ź and
press Select to reset the selected
Lamp hours to zero.
Ordering a Replacement Lamp
Replacement lamp can be ordered through your dealer. When ordering, give the following information to the dealer.
x Model No. of your projector: PDG-DXT10L, PDG-DXT10KL
x Replacement Lamp Type No: POA-LMP117
(Service Parts No. 610 335 8406)