5. Using On-Screen Display
80
Network Setting
See Network setting on page 82.
Standby mode
There are two standby modes available: Normal and Power-saving. Power-saving mode allows you to put the projector in
the standby condition to consume less power than Normal.
Note:
Be sure to connect the projector and computer while the projector is in standby mode and before turning on
the computer.
Select from the following:
Normal
Power-saving
Note:
The HTTP server functions are not available during Power-saving mode.
The MONITOR OUT function is not available during Power-saving mode.
Control through the PC Control connector and Network mode is not available during Power-saving mode.
For PC control and Network mode of the projector it is recommended to leave the projector in the Normal
mode.
Normal mode: POWER indicator: Orange light
WARNING indicator: Green light
Power-saving mode: POWER indicator: Orange light
WARNING indicator: Off
To Next Page
Loading...
