- 49 -
Electrical Adjustments
Group No. Item Function Range Initial Value
18 DIMMER CTRL LEVEL10 Bright level10 data: Bright level10 when less than the value 0~32767 750
19 DIMMER CTRL LEVEL11 Bright level11 data: Bright level11 when less than the value 0~32767 825
20 DIMMER CTRL LEVEL12 Bright level12 data: Bright level12 when less than the value 0~32767 900
21 DIMMER CTRL LEVEL13 Bright level13 data: Bright level13 when less than the value 0~32767 975
22 DIMMER CTRL LEVEL14 Bright level14 data: Bright level14 when less than the value 0~32767 1050
23 DIMMER CTRL LEVEL15 Bright level15 data: Bright level15 when less than the value 0~32767 1125
24 DIMMER AVE POINT Average point data for dimmer 1~16 4
50 Auto-Picture Control
0 Auto-Picture Control Forced OFF 0:follows to Menu, 1:Forced OFF 0 / 1 0
60 Remote Control
0 PAD_REPEAT Excutes when receiving PAD code N times 8-40 8
1 PAD Defeat Area in X direction PAD defeat area from the center of X-axis 0-127 48
2 PAD Defeat Area in Y direction PAD defeat area from the center of Y-axis 0-127 48
3 Wheel Move in X Direction Valid movable value of Wheel in X-axis 32-255 64
4 Wheel Move in Y Direction Valid movable value of Wheel in Y-axis 32-255 64
5 Wheel Valid Angle in X Direction Valid angle value of Wheel in X-axis 0-45 30
6 Wheel Valid Angle in Y Direction Valid angle value of Wheel in Y-axis 0-45 30
70 COOLING
0 COOLING_TIME Cooling time period after power off 10-120 90
1 FAN_OFF_TIME Cooling time period after set into standby mode 10-60 30
80 Projector Use time
0 PJ Time Projector accumulated use time in hours 0 ~ 9999 0
1 Display PJ Time in Special Menu 0:Disable1:Enable 0 / 1 0
2 PJ Time Reset Reset PJ Time when the value to 10 0 ~ 10 0
90 Operation History
0 OPERATION_HISTORY_1 Operation history in last operation 0~32767 0
~
49 OPERATION_HISTORY_50 Operation history last 50th operation 0~32767 0
110 Lamp Total On Time
0 Lamp 1 Accumulated Lamp-on time of Lamp 1 - 0
1 Lamp 2 Accumulated Lamp-on time of Lamp 2 - 0
111 Lamp On Time
0 Lamp 1 Lamp-on time of Lamp 1 - 0
1 Lamp 2 Lamp-on time of Lamp 2 - 0
112 Lamp Config
0 Lamp Config Change (300W) Lamp life selection for 300W(Step : 500h) 1000 ~20000 1500
1 Lamp Config Change (200W) Lamp life selection for 200W(Step : 500h) 1000 ~ 20000 1500
2 Lamp Config Change (100W) Lamp life selection for 100W (Step : 500h) 1000 ~ 20000 10000
113 Lamp Reset Counter
0 Lamp 1 Reset Counter Reset times of the Lamp1 time counter - 0
1 Lamp 2 Reset Counter Reset times of the Lamp2 time counter - 0
114 Lamp Time Information(LAMP1)
0 Lamp Normal Time Lamp-on time with the normal mode - -
1 Lamp Eco Time Lamp-on time with the eco mode - -
2 Lamp Total Time Total Lamp-on time with the coefficient - -
115 Lamp Time Information(LAMP2)
0 Lamp Normal Time Lamp-on time with the normal mode - -
1 Lamp Eco Time Lamp-on time with the eco mode - -
2 Lamp Total Time Total Lamp-on time with the coefficient - -
120 RC KEY Disable
0 RC Zoom & Focus Only 0:Enable / 1:Disable 0 / 1 0
1 RC / KEY All 0:Enable / 1:RC Disable /2:KEY Disable 0/1/2 0
2 Operation after Power Fail 0:deos not recover with key input / 1:recover with key input 0 / 1 0
140 Fan Control
0 Service Operate Target MODE
Target Mode -1:according to current mode 0: Normal mode1: Eco mode
-1~3 -1
1 Service Operate Target FAN Target Fan0:A1:B2:C3:D14:D25:E 0~5 0
2 Control Switch Control switch oftarget Fan0:Auto1:Manual 0 / 1 0
3 Fan Out LimitVoltMAX Max. voltage limit of target Fan * Voltage=Value/100 0 ~ 2000
4 Fan Out LimitVoltMIN Min. voltage limit of target Fan * Voltage=Value/100 0 ~ 2000
5 Fan Out LimitDACMAX DAC output for Max. Voltage limitation 0~255
6 Fan Out LimitDACMIN DAC output for Min. Voltage limitation 0~255
7 Manual Out Voltage in manual mode for target Fan in 0.01V unit 0~2000
8 Now Out Current voltage of target Fan - -
141 Fan Optiion
To Next Page
Loading...
