EN-19
Adjusting the Projected Image
Adjusting the Projector Height
The projector is equipped with two elevator feet to adjust the image height up to 9.0
degrees.
To raise the image:
1. Press the elevator button.
2. Raise the image to the desired height angle, then release the button to lock the
elevator feet into position.
To lower the image:
1. Press the elevator button.
2. Lower the image, then release the button to lock the elevator feet into position.
To avoid damaging the projector, make sure that the elevator feet are fully
retracted before placing the projector in its carrying case (supplied).
Elevator foot
Elevator button
To Next Page
Loading...
