To Next PageTo Next PageWhy does the LAMP REPLACE indicator light up yellow on my Sanyo PLC-WXU700?
The LAMP REPLACE indicator lights yellow on your Sanyo Projector because the projection lamp is nearing the end of its life. Replace the projection lamp with a new one promptly and reset the lamp replacement counter after the replacement.
What to do if my Sanyo PLC-WXU700 cannot be turned on due to an abnormal condition?
If your Sanyo Projector detects an abnormal condition and cannot be turned on, unplug the AC power cord, plug it in again, and try turning on the projector. If it turns off again, unplug the AC power cord and contact the dealer or the service center for service and checkup.
What to do if my Sanyo Projector cannot be turned on due to high temperature?
If your Sanyo Projector cannot be turned on due to high temperature, it means the temperature inside the projector is abnormally high. When the projector cools down enough and the temperature returns to normal, the POWER indicator will stop blinking, and the projector can be turned on. Also, check and clean the filter.
What to do if my Sanyo Projector cannot be turned on until cooling is completed?
If your Sanyo Projector cannot be turned on until cooling is completed, it is because the projector is either preparing for stand-by or the projection lamp is cooling down. Wait until cooling is completed, and the POWER indicator stops blinking.
How to turn on Sanyo Projector?
To turn on your Sanyo Projector, press the ON/STAND-BY button.
How to get Sanyo Projector out of stand-by mode?
To turn on your Sanyo Projector from stand-by mode, press the ON/STAND-BY button.
General