Sanyo PLC-WXU700 - Page 15

-15-
Mechanical Disassembly
Fig.5
b Power, Ballast, Lamp Cover Sw Board, Thermal Sw(SW902) removal
Isolation sheet (2 sheets)
Lamp cover
switch board
Themal switch
(SW902)
Power board
C(T3x6)x2
E (T3x6)
G(T3x6)
F (T3x6)
Ballast board
1. Remove the 2 screws A( T3x8) (top side), remove the 2 screws B (T3x8)
(bottom side) and remove screw G(T3x6) to remove the Power board assy.
2. Remove the Isolation sheet.
3. Remove 2 screws C(T3x6) to remove the Ballast board.
4. Remove the screw E (T3x6) and remove the Lamp cover switch board.
remove the screw F (T3x6) and remove the thermal switch (SW902).
B (T3x8)x2
C
B
A
A(T3x8)x2