Sanyo PLC-XF30 - Page 29

-37-
Not designated PC AV Component
210-14 & 16 AV White balance adjustment. 2 lamp mode ●
200-14 & 16 PC White balance adjustment. 2 lamp mode ●
211-14 & 16 AV White balance adjustment. Lamp-1 of 1 lamp mode ●
212-14 & 16 AV White balance adjustment. Lamp-2 of 1 lamp mode ●
1000-25 AV Color and Tint adjustment ●
1000-24 AV Color and Tint adjustment ●
1010-0 AV Green Video signal adjustment ●
1010-1 AV Green Video signal adjustment ●
1010-2 AV Red Video signal adjustment ●
1010-3 AV Red Video signal adjustment ●
1010-4 AV Blue Video signal adjustment ●
1010-5 AV Blue Video signal adjustment ●
5010-0 Component G Video signal adjustment ●
5010-1 Component G Video signal adjustment ●
5010-2 Component R Video signal adjustment ●
5010-3 Component R Video signal adjustment ●
5010-4 Component B Video signal adjustment ●
5010-5 Component B Video signal adjustment ●
0-0 Temperature monitor IC5801 Read only ●
0-1 Temperature monitor IC2541 Read only ●
1-0 Atmospheric Pressure monitor
IC886 Read only ●
10-0 RS232C Baud rate (0:9600 / 1:19200) ●
10-0 RS232C RTS/CTS Flow Control (0:Disable / 1:Enable) ●
111-0 Lamp-1 Lamp illumination time Read only ●
111-1 Lamp-2 Lamp illumination time Read only ●
930-0 Lamp mode 2 Lamp Mode
(See Note.)
●
930-1 Lamp mode Lamp-1 of 1 Lamp Mode
(See Note.)
●
930-2 Lamp mode Lamp-2 of 1 Lamp Mode
(See Note.)
●
998-0 Grid Test Pattern Display ●
Caution :
Other adjustment items are not related to service and a mainte-
nance. Don't change the data values of those adjustment items.
Otherwise it may cause loss of product safety.
Group-no. Adjustment Item Adjustment Mode
Note :
Group-no. 930
■ If the data value appears "11" on the screen, the lamp
mode is selected.
■ If the data value appears "0" on the screen, the lamp
mode is not selected. Set the data value to "10."
■ If the data value appears "99" on the screen, it is period
for cooling of the lamp. Wait until it is changed to "0."
Then set the data value to "10."