Sanyo PLC-XF30 - Optical Unit Removal

-11-
Remove 12 screws and then pull the optical unit upward and
remove.
NOTE :
Be careful of the attachment direction of Fan.
FN902 is Fan for an exhaust. *
1. Remove 3 screws A and remove the assembly motor & audio
2. Remove 4 screws B and remove the power holder.
3. Remove 4 screws C and remove the power holder top.
4. Remove 6 screws D and remove the assembly sub power.
5. Remove 4 screws E and remove the Fan (FN902).
6. Pull the assembly power upward and remove.
7. Pull the assembly PFC upward and remove.
5.
Assembly Motor & audio, assembly Power, assembly
PFC, assembly Sub power and Fan(FN902) Removal.
6.
Optical unit removal.
B
B
A
A
A
B
B
C
C
C
C
D
D
D
D
D
D
E
E
E
E
Power holder
power holder top
Ass'y Motor & audio
Ass'y Sub-power
Ass'y
PFC
Ass'y
power
FN902
The direction of a wind. *
Optical unit
FN902 :
See the Production change
notice of the cover. (Page-1)