Sanyo PLC-XF30 - Page 12

-12-
NOTE :
Be careful of the attachment direction of Fan.
FN908 is Fan for an exhaust.
Mark the Fans as they are removed from the cabinet bottom so
that they may be reassembled in the same location from which
they were removed.
1. Remove 5 screws A and remove the duct for FN907 and remove the Fan (FN907).
2. Remove 9 screws B and remove the Fans (FN903 and FN904) and remove the duct
for FN903/4.
3. Remove 8 screws C and remove the holder for FN908 and remove the Fan
(FN908).
4. Remove 8 screws D and remove the holder for FN905 and remove the Fan
(FN905) and remove the duct for FN905.
5. Remove 8 screws E and remove the AC switch unit.
6. Remove 4 screws F and remove 2 pins F and remove the handle.
7. Remove 8 screws G and remove the adjustable feet.
NOTE :
Be careful of the attachment direction of Fan.
FN906 is Fan for an exhaust.
1. Remove 4 screws A and remove the fan FN909 and remove the
fan FN910.
2. Remove 4 screws B and remove the assembly fan.
3. Remove 4 screws C and remove the fan FN906.
7.
Fans(FN906, FN909 and FN910)
removal.
8.
Fans(FN903, FN904, FN905, FN907 and FN908),
AC SW unit, Handle and Adjustable feet removal.
FAN908
FAN904
FAN907
FAN903
FAN905
DUCT for FAN903 & 4
HOLDER for FAN908
HOLDER for FAN905
DUCT for FAN905
DUCT for FAN907
AC SW UNIT
E
A
A
A
A
A
B
B
B
B
B
B
B
B
B
C
C
C
C
C
C
C
C
D
D
D
D
D
D
D
D
E
E
E
E
E
E
E
F
F
F
F
F
F
GX4
GX4
The direction of a wind.
Adjustable foot.
Handle
Adjustable foot.
A
A
A
A
B
B
B
B
C
C
C
C
FN910
FN906
FN909
The direction of a wind.
Assembly fan