■
Integrator-lens-in adjustment-1
■
Integrator-lens-out adjustment
Before Adjustment :
* Remove the flexible cables of LCD panels from
the assembly Main. And turn on the projector.
* Shift the adjustment position of Integrator-lens-
out temporarily until shade appears the right or
the left on the screen. After the Integrator-lens-
in-1 adjustment, readjust the Integrator-lens-out.
* Refer to "Integrator-lens-out adjustment" of next
step for the adjustment method.
Adjustment :
1. Insert light block sheets in front of the Red and Blue
panels to block the red and blue lights so that green
light is projected.
2. loosen 2 screws A.
3. Insert slot screwdriver into slot B, turn it until the shade
edge is sharp focus.
4. Tighten the 2 screws A to fix the integrator-lens-in unit.
Before Adjustment :
1. Remove the flexible cables of LCD panels from the
assembly Main. And turn on the projector.
2. Insert light block sheets in front of the Red and Blue
panels to block the red and blue lights so that green
light is projected.
3. If the shade appears on the left or right of the screen,
adjust in the following procedure.
Adjustment :
1. Loosen three screws-B.
2. Insert a slot screwdriver into slot-A, turn it and erase
shade.
3. Tighten the three screws B to fix the integrator lens-
out unit.
SCREW-A
SCREW-A
SLOT-B
SCREW-B
SCREW-B
BOTTOM
SIDE
SCREW-B
SLOT-A
To Next Page
Loading...
