Adjustment Item no.
Adjustment Group no.
Alignment procedures
Service adjustment menu operation
■ Readjustments after Parts Replacement
After replacing electric parts and optical parts, electric readjustment and optical readjustment are required.
Refer to the section of "parts list" for the required readjustment items after parts replacement.
(Refer to page 70.)
■ To enter the "service mode."
To enter the service mode, press the "MENU" and
"IMAGE" buttons on the projector simultaneously and
hold for 2 seconds. As shown in a figure, a service mode
display appears on a screen.
■ Adjustment.
Adjust service data using the following control buttons.
1. "POINT RIGHT" -- A group number increases.
2. "POINT LEFT" ---- A group number decreases.
3. "POINT UP" ------- An item number increases.
4. "POINT DOWN" -- An item number decreases.
5. "VOLUME +" ------ An adjustment value increases.
6. "VOLUME - " ----- An adjustment value decreases.
■ To exit the "service mode."
Press the "POWER on/off" button only once on the projec-
tor or remote control unit to quit the service mode.
To enter the "service mode."
Press the "MENU" and "IMAGE" buttons on the projector
simultaneously and hold for 2 seconds.
To Next Page
Loading...
