Sanyo PLC-XF46N - Page 73

Optical adjustment
- 73 -
Adjustmen
t
Tool
Screw-B
LCD Panel Bracket
Part-A
Screw-
A
LCD Panel
Bracket hole
■ CONVERGENCE ADJUSTMENT TOOL INSTALLATION AND REMOVAL
Note; Before mounting the Adjustment Tool, set adjustment screws of Adjustment Tool in center of the adjustment
range. Refer to Screw Setting. (Fig.59b)
1. Loosen 2screws-A of Prism/LCD panel unit. See Fig.60c.
CAUTION: When loosening the screws-A, do not touch the other mechanical part or give it shock.
2. Fully loosen 2screws-B on the Adjustment Tool. See Fig.60a, 60b.
3. Fully slide the Adjustment Tool part-A into the LCD Panel Bracket hole.
4. Mount Adjustment Tool on the Prism/LCD panel unit with screws-C attached with Adjustment Tool along the
guide on top of Prism Ass'y. See Fig.60d (next page)
CAUTION: Do not use other kind of screws for mounting, otherwise Prism/LCD panel unit may be damaged.
5. Tighten screws-B and hold the LCD Panel Bracket. See Fig.60a, 60b.
Screw-B
Screw-C
Adjustment Tool
Loosen 2 Screws-B before installation.
LCD Panel bracket
Prism/LCD Panel
unit
Tighten 2 Screws-B and
hold the LCD Panel bracket
Tighten 2 Screws-C and
hold the Prism/LCD Panel
unit
Slide the
Adjustment Tool.
Insert Adjustment Tool Leg (2 Legs) into
LCD Panel Bracket holes, and tighten
screws-B and hold LCD Panel Bracket
with Adjustment Tool.
Fig. 60b
Fig. 60a
Fig. 60c
Step 2 Step 3 Step 4
Prism/LCD Panel unit