Sanyo PLC XU115 - XGA LCD Projector Function Guide

11
Formatting the SD memory card
A new SD memory card or a card formatted by computer or camera must be formatted by this product.
Memory Viewer function may not operate properly with a card formatted by other equipment.
* It cannot be formatted when the lock switch of the card is set to "LOCK" position.
1.Inthememoryviewermode,pressAUTO SETUP/CANCEL button. The browser window appears on
the screen.
2.PressAUTO SETUP/CANCEL button again. The cursor moves to menu item.
3. Select "Format" from "Menu" with the point buttons and press SELECT button. The format
confirmation window appears.
4. Select "Yes" with the point buttons and press SELECTbuttontostartformatting.Ittakesabout1-2
seconds to complete the formatting.
Note:
✐ During formatting the SD memory card, do not turn off the power or eject the card because the data
in the card might get damaged. During formatting, the SD memory card indicator is blinking.
*ThedataconvertedbytheNetworkViewer5[FileConverter1]canbestoredintotheSDmemorycard
mounted on the projector directly. For further information, refer to chapter Network Viewer function,
"Setting ofoutput destinationand conversionmode"(p.113)described ontheseparatedNetwork
Owner's manual for Windows.
*TheprogramfilecreatedbytheProgramEditorcanbestoredintotheSDmemorycardmountedon
the projector directly. For further information, refer to chapter Network Viewer function, "Creating a
programfile"(p.115)describedontheseparatedNetworkOwner'smanualforWindows.

Sanyo PLC XU115 - XGA LCD Projector Specifications

General

Brand	Sanyo
Model	PLC XU115 - XGA LCD Projector
Category	Projector
Language	English