To Next PageTo Next PageWhat to do if all LED indicators are not lighting on Sanyo PLC-XU350A Projector?
If all LED indicators are not lighting on your Sanyo Projector, the primary power supply circuit may not be operating properly. Check the power primary circuit and parts, including the AC cord, F601 (Fuse), Power board, and SW902 (Thermal sw.) for shorts in normal operation.
Why is there no image on my Sanyo Projector?
If your Sanyo Projector displays no image, several factors could be the cause. First, verify the connection between your computer or video equipment and the projector. Ensure the input signal is correctly output from your computer, adjusting monitor output settings if necessary. Allow approximately 30 seconds for the image to appear after turning on the projector. Also, check the input signal, color system, video system, or computer system mode. Confirm that the operating temperature is within the specified range. Finally, if 'No Show' is active, press the NO SHOW button or any other button on the remote control to restore the image.
What to do if the remote control does not work with my Sanyo PLC-XU350A?
If the remote control isn't working with your Sanyo Projector, try these steps: * Check the batteries and replace them if needed. * Ensure there are no obstructions between the remote and the projector. * Make sure you're within the remote's operating range (16.4 feet or 5 meters). * Verify the remote control code matches the projector's. * Unlock the Key lock function for the remote control.
General| Brightness | 3500 ANSI Lumens |
|---|---|
| Contrast Ratio | 2000:1 |
| Display Technology | LCD |
| Aspect Ratio | 4:3 |
| Projection Size | 30 to 300 inches |
| Zoom Ratio | 1.2x |
| Resolution | 1024 x 768 pixels (XGA) |
| Lamp Life | 2000 hours (Standard Mode) / 3000 hours (Eco Mode) |
| Throw Distance | 1.2 m |
| Input Ports | S-Video, Composite Video |
| Output Ports | Audio |
