Sanyo PLC-ZM5000L - Page 48

8VHWKH3RLQWŻŹEXWWRQVWRDGMXVWWKHJDPPDYDOXH
to obtain a better balance of contrast (from 0 to 15).
3UHVVWKH3RLQWŻEXWWRQWRGHFUHDVHWKHVKDUSQHVV
RIWKHLPDJHSUHVVWKH3RLQWŹEXWWRQWRLQFUHDVHWKH
sharpness of the image (from 0 to 31).
An interlaced video signal can be displayed in
SURJUHVVLYHPRGH3UHVVWKH3RLQWŻŹEXWWRQVWR
change the progressive scan mode.
Off............. Progressive scan mode is Off.
On ............. Progressive scan mode is On.
Film........... For watching a film. With this function,
the projector reproduces pictures faithful
to the original film quality.
Noise interference on the screen can be reduced.
3UHVVWKH3RLQWŻŹEXWWRQVWRFKDQJHWKHQRLVH
reduction mode.
Off............. Noise reduction mode is Off.
On ............. Noise reduction mode is On.
3Note:
Progressive FDQQRWEHVHOHFWHGZKHQ480p,
575p, 720p, or 1080p LVVHOHFWHGS
Noise reduction FDQQRWEHVHOHFWHGZLWKWKH
FRPSXWHULQSXWDQGZKHQWKHYLGHRVLJQDOIRUPDW
LV 1080pS
To reset the adjusted data, select Reset and press
the SELECT button. A confirmation box appears and
then select Yes. All adjustments will return to their
previous figures.
To store the adjusted data, select Store and press
WKH3RLQWŹRUWKH6(/(&7EXWWRQ8VHWKH3RLQW
ŸźEXWWRQVWRVHOHFWRQHIURP,PDJHVWRDQG
press the SELECT button.
A confirmation box appears and then select Yes.
Stored data can be called up by selecting an Image
(1-10) in the Image Mode Selection on page 46.
A confirmation box appears
and then select Yes.
Store
Video Input
3UHVVWKH3RLQWŻEXWWRQWROLJKWHQUHGJUHHQEOXHWRQH
RIWKHEODFNOHYHORIDQLPDJHSUHVVWKH3RLQWŹEXWWRQ
to deepen red/green/blue tone of the black level of an
image (from 0 to 63).
Offset (Red/Green/Blue)
Sharpness
Gamma
Noise reduction
Progressive
Reset
Store
48