Sanyo PLC-ZM5000L - List of Picture in Picture; Serial Control Interface

Appendix
This projector provides a function to control and monitor the projector's operations by using the RS-232C
serial port.
Connect a RS-232C serial cross cable to CONTROL
PORT on the projector and serial port on the PC.
(See p.19)
Launch a communication software provided with PC
and setup the communication condition as follows:
1
2
3
Baud rate : 9600 / 19200 bps
Parity check : none
Stop bit : 1
Flow control : none
Data bit : 8
Type the command for controlling the projector and
then enter the "Enter" key.
Example
When you want to change the input to INPUT 2,
Type 'C' '0' '6' 'Enter'.
3Note:
Enter with ASCII 64-byte capital
characters and one-byte characters.
3Note:
 7KHGHIDXOWRIWKHEDXGUDWHLVVHWWR
19200 bps,IDQHUURURFFXUVLQWKH
FRPPXQLFDWLRQFKDQJHWKHVHULDOSRUW
DQGWKHFRPPXQLFDWLRQVSHHGEDXG
UDWH
Serial Control Interface
Operation
List of Picture in Picture
o : Picture in Picture combinations are enabled.
x : Picture in Picture combinations are disabled.
3Note:
 :KHQWKHLQSXWVLJQDOVLVDUHLQFRPSDWLEOHX mark will be displayed on the Main/Sub picture.
 'HSHQGLQJRQWKHIUHTXHQF\RUVLJQDOW\SHRI3&$9LQSXWWKHGLVSOD\UHVROXWLRQPD\EHORZHUHG
or images may not be displayed on the Main/Sub picture.
<Display resolution is lowered when;>
  ,QSXWWLQJ3&DQDORJVLJQDOV%HWZHHQ0+]
<Images are not displayed and X mark appears when;>
  ,QSXWWLQJ3&DQDORJVLJQDOV0RUHWKDQ0+]
  ,QSXWWLQJ3&GLJLWDOVLJQDOV0RUHWKDQ0+]
  ,QSXWWLQJ$9GLJLWDOVLJQDOVS
<Picture in Picture is disabled when;>
  ,QSXWWLQJVLJQDOIRUPDWV:8;*$:;*$8;*$8;*$8;*$8;*$'S
DVI
DVI
89