Sanyo SAP-KMRV123GJH - Page 42

6
Unit Display and Operation Selector
IMPORTANT
Avoid using radio equipment such as mobile phone near
(within 1 m) the remote control receiver. Some radio
equipment may cause malfunction of the unit.
If the trouble happens, disconnect power and restart the
air conditioner after a few minutes.
REMOTE CONTROL This section picks up infrared signals from the remote control unit
receiver (transmitter).
Operation selector
ON position This position is for operating the air conditioner with the wireless
remote control unit.
Set the selector normally in this position.
OFF position Switch the selector to the OFF position if you are not going to use the
air conditioner for a few days or longer.
WARNING The OFF position does not disconnect the power. Use the main power
switch to turn off power completely.
TEST position This position is used only when servicing the air conditioner.
CAUTION Do not set at the TEST position for normal operation.
DEMO position This position is used only when setting address of the remote control
unit.
OPERATION lamp This lamp lights when the system is in the continuous AUTO (red,
orange or green), HEAT (red), DRY (orange) and COOL (green) mode.
TIMER lamp This lamp lights when the system is being controlled by the timer.
SERVICE lamp When a fault occurs in the air conditioner, this lamp turns on or flashes
in combination with the other two lamps to indicate the type of fault.
OI-563-06EG
KMRV93/123/183
INDOOR UNIT
Operation
selector
SERVICE
lamp
TIMER
lamp
OPERATION
lamp
REMOTE CONTROL
recelver
TIMER
lamp
OPERATION
lamp
KMRV243
INDOOR UNIT
Operation selector
01ENASAP-KMRV93GJHp2-21 3.2.13, 10:21 AMPage 6 AdobePageMaker6.5J/PPC