18 2A. Phone Basics
Installing the Battery
See “Setting Up Your Phone” on page 2.
Removing the Battery
1. Make sure the power is off so that you don’t lose
any stored numbers or messages.
2. Slide the battery cover latch into its unlock position
and slide the battery cover downward to remove it.
3. Lift the battery up and remove it from the phone.
Charging the Battery
Keeping track of your battery’s charge is important. If
your battery level becomes too low, your phone
automatically turns off, and you will lose any
information you were just working on.
Always use a Sprint-approved or Kyocera-approved
desktop charger, travel charger, or vehicle power
adapter to charge your battery.
1. Plug the phone charger into an electrical outlet.
2. Plug the other end of the phone charger into the
micro-USB connector located on the upper right
side of your phone.
With the Sprint-approved Li-Ion battery, you can
recharge the battery before it becomes completely run
down.
WARNING
Do not handle a damaged or leaking Li-Ion
battery as you can be burned.
To Next Page
Loading...
Need help?
General
