Sanyo VHR-M261EV - Brake Assembly S; Brake Assembly T; Arm Assembly Tension; Reel S;Reel T

DECK MECHANISM DISASSEMBLY
4-7
(For Jog Shuttle Models)
Spring S Brake
Brake Assembly S
Arm Assembly
Tension
(C)
(A)
Band
Assembly
Tension
Spring Tension
Reel S
Reel T
Spring T Brake
Brake Assembly T
B
Fig. A-4
11. Brake Assembly S (Fig. A-4-1)
1) Remove the Spring S Brake.
2) Hold the (A) part shown above Fig. A-4-1 and turn to the
clockwise direction, and then lift up the Brake Assembly S.
(1) When reassembling, be careful not to change the Spring
with below No.12.(Refer to Fig. B-2).
12. Brake Assembly T (Fig. A-4-2)
1) Remove the Spring T Brake.
2) Hold the (B) part shown above Fig. A-4-2 and turn to the
counterclockwise direction, and then lift up the Brake
Assembly T.
(1) When reassembling, be careful not to change the Spring
with above No.11.(Refer to Fig. B-2).
13. Arm Assembly Tension (Fig. A-4-3)
1) Remove the Spring Tension.
2) Hold the (C) part shown above Fig. A-4-3 and turn to the clock-
wise direction, and then lift up the Arm Assembly Tension.
(1) When reassembling, be careful not to change the Spring
with above No.11,12.(Refer to Fig. B-2).
14. Reel S (Fig. A-4-4) & Reel T (Fig. A-4-5)
1) Lift up the Reel S and Reel T.
(1) When reassembling, be careful not to change the Reel S
and Reel T each other.
(2) Confirm two Slide Washers under the Reel S and Reel T.
NOTE
Spring T Brake
Spring S Brake
Spring Tension
NOTE
(Difference for Springs)
Color (Black)
Three Holes
Reel S
Reel T
(Fig. B-2)
NOTE
NOTE
(Fig. A-4-1)
(Fig. A-4-5)
(Fig. A-4-3)
(Fig. A-4-4)
(Fig. A-4-2)