Sanyo VHR-M261EV - Gear Drive;Gear Cam;Gear Connector; Bracket Assembly L;D Motor

DECK MECHANISM DISASSEMBLY
4-11
Washer (W1)
Gear Drive
Gear Cam
Gear Connector
Hole (A)
Hole (B')
Hole (B')+(B)
Chassis
Hole (A')+(A)
Gear Cam
Gear Connector
Brake Assembly Capstan
(4HD/4HD Hi-Fi Model Only)
Hole (A')
Bracket Assembly
L/D Motor
H1
H2
Hole (B)
Fig. A-8
27. Gear Drive (Fig. A-8-1)/
Gear Cam (Fig. A-8-2)/
Gear Connector (Fig. A-8-3)
1) Remove the Washer(W1) and lift up the Gear Drive.
2) Lift up the Gear Cam.
3) Lift up the Gear Connector.
(1) When reassembling, confirm that the Hole (A) of the
Gear Connector is aligned to the Hole (A') of the Chassis
(Fig. A-8-3).
(2) When reassembling, confirm that the Hole (B) of the
Gear Cam is aligned to the Hole (B') of the Chassis (Fig.
A-8-2).
(3) When reassembling, confirm that the (C) part of the Gear
Cam is aligned to the (D) part of the Gear Drive as shown
Fig. B-3
28. Bracket Assembly L/D Motor (Fig. A-8-4)
1) Unhook the three Hooks(H1),(H2) and push down the
Bracket Assembly L/D Motor.
NOTE
Gear Cam (C)
Gear Drive (D)
Hook (H1), (H2)
Chassis
(Fig. B-3)
(Fig. A-8-1)
(Fig. A-8-2)
(Fig. A-8-3)
(Fig. A-8-4)