11 English
Setting to the card reader mode
1 Start your computer, and use the supplied USB interface cable to
connect the docking station to the computer.
h Connect the docking station’s USB/AV terminal to the computer’s USB
connector.
2 Press the ON/OFF button to turn the camera on, and set the camera
in the docking station.
h The USB Connection Screen appears on the camera’s monitor.
3 Select “CARD READER”, and press the SET button.
h When the camera’s monitor unit is closed and the camera is set in the
docking station, press the operation mode button [ ] on the docking
station.
USB CONNECTION
CARD READER
PictBridge
PC CAMERA
CANCEL
To USB connector on the computer
Supplied dedicated USB interface cable
i Insert the plug with the [n] mark facing up.
USB/AV terminal
To AC adaptor
To Next Page
Loading...
