86
Chapter 7 Controlling the projector
Viewer auto setting all together
"Viewer auto display" can be set all together. Set "ON" the multi
control setting and select [3] Auto display from Viewer sub menu
(selected by ‘Multi-control’ - “Network Viewer” menu). Set the
display time periods and repeat times for the auto image display.
After clicking Start button, the registered projectors start playing
back the auto image display in sequential.
✐ For further information of the Auto display, see "Using the network
viewer function". (+p.124)
✐ This is effective only if the multi control item of the registered projector is
set to either "Control & Image" or "Image".
To Next Page
Loading...
