Sapling SBP Series - Manual Controls; Button-Based Operations

67
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
67
The Sapling Company, Inc.
670 Louis Drive
Warminster, PA 18974
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Some functions of the IP Digital Clock can be controlled through the two push-buttons on the face of
the clock. That said, it is ALWAYS preferable to use the Web Interface and IP monitor software when
commanding the clock, as these buttons become difficult to access when the clock has been installed on a
high wall.
Display IP Address
When the top and bottom buttons are simultaneously pressed and held for two seconds, the clock will
display the number groups of the IP address. For example, if the IP address of the clock is 192.168.0.80,
then the following groups will appear:
[192] [168] [000] [080]
The clock will cycle through the groups twice, then automatically return to displaying the time.
Simple Count Up
A user can set the clock to simple count-up mode by pressing and releasing the bottom button. When
activated, the clock will switch to 00:00:00 (or 00:00 on a 4-digit clock) and begin counting up.
Pressing the bottom button again will start or resume count up if the count-up is not running, or pause the
count-up if the count up is running.
To exit this mode, quickly press and release the top button and the clock will show the time again.
Manual Controls
Top Button
Bottom Button