Entris
®
BCE Operating Instructions 15
Installation
5.3 Unpacking
Procedure
t Unpack the device.
t If the device is stored temporarily: Observe the storage
information (see Chapter 13.1, page 33).
t Keep all parts of the original packaging, e.g. to return the
device.
5.4 Removing the Transport Lock
Procedure
1
t Remove the transport locks (1)
and retain them for later use.
5.5 Assembling the Device
Procedure
3
2
1
t Place the frame draft
shield (1) on the balance.
t Attach the shock absorbers (2).
t Place the weighing pan (3)
on top.
5.6 Acclimatizing the Device
When a cold device is brought into a warm environment:
The temperature difference can lead to condensation from
humidity in the device (moisture formation). Moisture in the
device can lead to malfunctions.
Procedure
t Allow the device to acclimatize for approx. 2 hours at the
installation site. The device must be disconnected from the
power supply beforehand.
To Next Page
Loading...
