12 Entris
®
BCE Operating Instructions
Operating Concept
Symbol Designation Description
[Gross] display Indicates that a gross value is being displayed.
[Selection] display In the menu: Identifies the selected parameter.
If the “Calculation” or “Density determination” application is active: Indicates that a
calculated value is being displayed.
[Unit symbol] display Indicates the set weight unit, e.g. [g] for “grams”.
[Quantity] Indicates that a quantity is being displayed.
[Invalid weight value]
display
− Indicates that the display does not contain a weight value, but is instead the
calculated result of an application, e.g. for the “Totalizing” application.
− For conformity-assessed devices: Indicates a fault. The cause of this fault is displayed
after pressing the [Change] key.
4.4 Menu Structure
4.4.1 “Main Menu” Menu Structure
t Navigating in menus (see Chapter 4.5, page 14).
Level 1 Level 2 Description
SETUP BALANCE Set the functions of the device.
GEN.SERV.
“General services”
Reset the menu to factory settings.
DEVICE RS-232
“RS232, 9-pin”
Define the parameters for the COM interface.
USB
“USB-C”
Define the parameters for the USB interface.
EXTRAS Define the functions of the operating display.
DATA.OUT.
“Data output”
COM. SBI
“SBI communication”
Configure the automatic data output.
PRNT.PAR.
“Printout settings”
Perform the settings for the printout.
PC.DIREC.
“Direct transfer of data
(PC)”
Define the output format for the data exchange between the balance and
the PC.
To Next Page
Loading...
Need help?
General