Entris
®
BCE Operating Instructions 33
Decommissioning
11 Decommissioning
11.1 Decommission the Device
Procedure
t Turn the device off.
t Disconnect the device from the power supply.
t Disconnect the device from all connected devices and all
accessories, e.g. printer.
t Clean the device (see Chapter 9.2, page 30).
12 Transport
12.1 Installing the Transport Lock
Procedure
t Switch off the device.
t Disconnect the device from the power supply.
t Disconnect the device from all connected devices and all
accessories, e.g. printer.
t Remove frame wind shield, weighing pan and associated
components (see Chapter 9.1, page 30)
1
t Attach the transport locks (1).
12.2 Transporting the Device
Procedure
t Use suitable conveyance devices, e.g., trolleys, for long
transport routes.
13 Storage and Shipping
13.1 Storage
Procedure
t Turn the device off.
t Disconnect the device from the power supply.
t Disconnect the device from all connected devices,
e.g. printer.
t Store the device according to the ambient conditions
(see Chapter 15.1, page 35).
13.2 Returning the Device and Parts
Defective devices or parts can be sent back to Sartorius.
Returned devices must be clean, decontaminated, and packed
correctly, e.g. in their original packaging.
Transport damage as well as measures for subsequent cleaning
and disinfection of the device or parts by Sartorius shall be
charged to sender.
WARNING
Risk of injury due to contaminated devices.
Devices contaminated with hazardous materials (nuclear,
biological, or chemical – NBC) will not be accepted for repair
or disposal.
t Observe the information on decontamination
(see Chapter 14.1, page 34).
Procedure
t Decommission the device.
t Install the transport lock.
t Contact Sartorius Service for instructions on how to return
equipment or parts (please see our website at www.
sartorius.com for return instructions).
t Pack the device and its parts properly for return, e.g. in
their original packaging.
To Next Page
Loading...
Need help?
General