24
Pin Assignment Chart for the Interface RS-485
RS-485, 3-m Cable
Male Connector:
Type C091D, 12-pin round connector with threaded locking ring, Amphenol (IP67))
Pin Assignment
A RxD-TxD-N
B Not Connected
C Not Connected
D Not Connected
E Signal GND
F Menu Access Switch for Calibration/
Adjustment (routed externally)
G VCC (24V Power Supply)
H Not Connected
J GND (24V Power Supply)
K GND (24V Power Supply)
L RxD-TxD-P
M VCC (24V Power Supply)
Female Interface Connector (Recommended):
Type C091D, 12-pin, Amphenol (IP67)
Type of cable: AWG 24 specification
Be sure to follow the instructions given for connecting the weighing
platform to the power supply!
To Next Page
Loading...
