Getting Started
Storage and Shipping Conditions
– Do not expose the balance to extreme
temperatures, moisture, shocks, blows
or vibration.
Unpacking the Balance
§ After unpacking the equipment, please
check it immediately for any external
damage
$ If damage is evident, refer to the
instructions under “Safety Inspection"
in the chapter entitled “Care and
Maintenance."
$ Save the box and all parts of the
packaging for any future transport.
Disconnect all cables before packing
the balance for shipping!
Equipment Supplied
– Balance
– Weighing pan
– AC adapter
– Dust cover
Additional equipment for models
with readabilities < 0.1 mg and LE…-DS
models:
– Electronics box
(models LE26P, LE225D only)
– Draft shield with base plate
– Shield ring
Additional equipment for models with
a readability of 1mg:
– Draft shield with shield plate
– Weighing pan receptor
– Base plate
Installation
Choose a location that is not subject
to the following negative influences:
– Heat (heater or direct sunlight)
– Drafts from open windows and doors
– Extreme vibrations during weighing
– Excessive moisture
Conditioning the Balance
Moisture in the air can condense on
the surfaces of a cold balance whenever
it is brought into a substantially warmer
place. If you transfer the balance to
a warmer area, make sure to condition
it for about 2 hours at room tempera-
ture, leaving it unplugged from AC
power.
Seal on Balances Verified for Use in
Legal Metrology in the EU*:
EU legislation requires that a control
seal be affixed to verified balances
of accuracy class K. The control seal
consists of a sticker with the “Sartorius"
logo. If the seal is broken, the verifica-
tion becomes null and void and the bal-
ance must be re-verified.
* Including the Signatories of the Agree-
ment on the European Economic Area
4
To Next Page
Loading...
Need help?
General
