Sartorius LP Models - Balance Configuration Options; Interface and Printing Settings; Application Printing and Extra Functions

19
Configuring the Balance
Setup menu 1 to 4 see previous pages
for applications
5 Interface 5 1 see previous page
5 2 Parity 5 2 2 Space
5 2 3 ο Odd
5 2 4 Even
5 3 No. of stop bits 5 3 1 ο 1 stop bit
5 3 2 2 stop bits
5 4 Handshake 5 4 1 Software handshake
mode 5 4 3 ο Hardware handshake,
1 character after CTS
5 5 Communication 5 5 1 ο SBI
mode 5 5 2 xBPI
5 5 4 YDP01IS
5 5 5 YDP02
5 5 6 YDP03
5 5 7 YDP01IS Label printer
5 5 10 YDP02IS
5 5 11 YDP02IS Label printer
5 5 14 YDP04IS
5 5 15 YDP04IS Label printer
5 6 Network address 5 6 1 ο Address 0
5 6 x Addresses 1 to 30
5 6 32 Address 31
6 Print for 6 1 Print manual/ 6 1 1 Manual without stability parameter
weighing automatic 6 1 2 ο Manual with stability parameter
6 1 4 Auto print without stability parameter
6 1 5 Auto print at stability
6 1 6 Auto print after weight change**
6 2 Stop auto print 6 2 1 Use p key
6 2 2 ο Not possible
6 3 Time-dependent 6 3 1 1 display update
auto print 6 3 2 2 display updates
6 3 4 10 display updates*
6 3 7 100 display updates*
6 4 Print -> 6 4 1 ο Off
autotare 6 4 2 On
7 Print for 7 1 Print application 7 1 1 ο Off
application parameters 7 1 2 All parameters
7 1 3 Only main parameters
7 2 Line format 7 2 1 For raw data
7 2 2 ο For other applications/GLP
7 3 Print net total 7 3 1 ο Auto print net
7 3 2 Auto print tare
8 Extra functions 8 1 Menu 8 1 1 ο Parameter settings alterable
8 1 2 Parameter settings readable
8 2 to 8 10 see next page
9 Balance menu see next page
Level 1
Level 2
Level 3
Factory setting
Menu item
* = setting not applicable in balances verified for use in legal metrology
** = Auto print if change in weight >10 d and has stable readout; function enabled when load <5 d