7
Getting Started
Separate Operation of the Display Unit
● Turn the balance upside down and lay it on a padded surface
to avoid damage to the weighing system.
● Use a screwdriver to remove the 2 screws from the display unit retainer
● Remove the display unit
> Cable lengths
– LP balances with a weighing capacity ≤ 12 kg: 55 cm
– LP balances with a weighing capacity ≥ 16 kg: 80 cm
k See the chapter entitled “Accessories” for information on longer cables
k If you wish to use a longer cable, it must be installed by an authorized
Sartorius service technician
Options for Mounting the Display Unit for a Balance with
a Weighing Capacity ≥ 16 kg
The display unit can be mounted as follows:
– on the short side of the weighing cell (factory mounting)
– on the back (long side) of the of the weighing cell
● Turn the weighing cell over
● Remove the fastening screws from the display unit retainer
● Remove the fastening screws from the plate that covers the cable raceway
(channel) and remove the plate
● Fasten the display unit retainer onto the back of the weighing
cell with the 2 Allen screws
● Thread the cable through the raceway and replace the cover plate
To Next Page
Loading...