71
Operating the Balance
Pin Assignments for the Female Interface Connector
Pin Input Function (8 8 1) Output Function (8 8 2)
15 p key Remove universal switch (see below)
16 t key Control output port 1: lighter
17 q key Control output port 2: equal
18 v key Control output port 3: heavier
19 c key Control output port 4: “set”
Interface Port Input/Output
You can connect a checkweighing
display and a remote universal
switch to the interface port (factory
setting).
When you connect a remote
universal switch, you need to change
the following parameters.
Remote universal switch
Function Menu setting
p key 8 4 1
t key 8 4 2
q key 8 4 3
v key 8 4 4
c key 8 4 5
w key 8 4 6
See “Pin Assignment Chart” in
the chapter entitled “Overview” for
detailed information.
Printing an ISO/GLP-compliant
Record
In the Setup menu, you can configure
whether
– no ISO/GLP-compliant record
will be printed (off, 8 10 1),
– an ISO/GLP-compliant record
will be printed after calibration/
adjustment (Only for cal./adj.,
8 10 2), or
– every printout will be an
ISO/GLP-compliant record
(always ON, 8 10 3)
Undoing All Parameter Changes –
Reset Function
There is a factory setting for
each parameter. In the Setup menu,
you can configure whether
– menu factory settings will
be restored after exiting Setup
(Restore, 9 1 1), or
– menu factory settings will not
be restored after exiting Setup
(Do not restore, 9 1 2)
To Next Page
Loading...