To Next Page

To Previous Page

Key ) - > 2 sec Function

Allocation

Purpose

The key ) - > 2 sec is usually used

for the calibration/adjustment function.

The following additional functions can

be allocated to the key when the service

mode is activated:

– External linearization with default

weights (menu item 1.9.6)

– External linearization with the lineariza-

tion weights (menu item 1.9.7) entered

under menu item 1.18

– Setting the preload (menu item 1.9.8)

– Clearing the preload (menu item 1.9.9)

!Once linearization has been completed,

or after a preload has been set or

cleared the function of the key )- > 2

sec must be reallocated back to its nor-

mal function in the Setup menu (e.g.

external calibration/adjustment with

default weights)

1717

Menu structure for key ) - > 2 sec function allocation

1. 9. Calibration, adjustment

1. 9. 1 External calibration/adjustment with default weights (service mode not required)

1. 9. 3 External calibration/adjustment with user-defined weights (entered under 1-18), (service mode not required)

1. 9. 6 External linearization with default weights

1. 9. 7 External linearization with user-defined weights (entered under 1-18)

1. 9. 8 Set preload

1. 9. 9 Clear preload

1. 9. 10 Key blocked

Sartorius MIS2 User Manual

Other manuals for Sartorius MIS2