Sartorius mLINE - Personal Identification; Pipette Holder and Carousel Stand; Installing the Pipette Holder; Carousel Stand

5
A
B
C
5. Personal identification
Each mLINE pipette can be identified with a tag
located under the ID window which on the finger
support.
1. Remove the ID window by using the
calibration tool.
2. Remove the tag and mark the identifying
information on it.
3. Position the tag in place and clip the window
back into place.
6. Pipette holder and
carousel stand
For convenience and safety, always keep the
pipette vertically on its own holder or carousel
stand when not in use.
Cat.No. Product
725600 Carousel Stand for 6 pipettes
725610 Pipette Holder for 1 pipette
6.1. Installing the pipette holder
1. Clean the shelf surface with ethanol.
2. Remove the protective paper from the
adhesive tape.
3. Install the holder by pressing it against the
edge of the shelf.
4. Place the pipette onto the holder.
6.2. Carousel stand
A convenient and ergonomical Carousel stand for
six mLINE pipettes is also available
7. Calibration tool
(also tube and ID window opener)
The calibration tool is designed for the following
purposes:
1. Tool for recalibration (A).
2. Opening tool for the ID window and lid of
the calibration nut (B).
3. Opening tool for the tubes (C).