Saswell T19WHB-7-RF - Low Battery Warning; Temporary Temperature Change (Hold); Constant, Permanent Temperature Change (Hold)

24
Function and thermostat description
For easier understanding of this user manual, use the previous page, where the display and the buttons are described
as a reference. It will be easier to navigate through the whole setting process.
Low battery warning
Always insert new alkaline and non-rechargeable batteries when using the thermostat. When the battery replacement
symbol appears, the thermostat will only work for an average of 30 days. The battery life itself depends on the use
frequency of the thermostat and the quality of the batteries themselves. In case you do not use the thermostat for a
long time, we recommend that you remove the batteries from the thermostat. This prevents damage to the device if the
battery is leaking or simply extends the life of the batteries.
Temporary temperature change (hold)
In case you are using heating program schedule and you don’t like the currently programmed temperatures, you can
change the currently set temperature until the next heating program change. You can easily activate this function by
short pressing button or . The display will show the temperature you are setting. When you’re happy with the
selected temperature, the device will save the value itself after a few seconds or you can short press button. When
this function is enabled, the display will show icon 4 and icon 5 simultaneously – which means heating schedule is on
and temperature hold is on. The function turns off automatically when the next heating program is scheduled or by
simply pressing the button.
Constant, permanent temperature change (hold)
In case you are using heating program schedule and you don’t like the currently programmed temperatures, you can
change the currently set temperature at your likings. This also comes handy when you’re away for a longer time (eg.
holiday) and you want to lower the temperature as much as possible for better energy savings. You can easily activate
the function by short pressing on the button . Display will show only icon 5. Now you can set the desired temperature
by pressing buttons and . If you want to exit this function, simply short press