This meter has been designed according to IEC 61010 concerning electronic measuring instruments with a measurement category ( CAT II
600V ) and pollution degree 2.
Warning
To avoid possible electric shock or personal injury, follow these guidelines:
DY03005 Users Manual
Do not use the meter if it is damaged. Before you use the meter, inspect the case. Pay particular attention to the insulation surrounding
the connectors.
Inspect the test leads for damaged insulation or exposed metal. Check the test leads for continuity. Replace damaged test leads before
you use the meter.
Do not use the meter if it operates abnormally.
Protection may be impaired. When in doubt, have the meter serviced.
Do not operate the meter where explosive gas, vapor, or dust is present.
Do not apply more than the rated voltage, as marked on the meter, between terminals or between any terminal and earth ground.
Before use, verify the meter's operation by measuring a known voltage.
When measuring current, turn off circuit power before connecting the meter in the circuit. Remember to place the meter in series with
the circuit.
●
●
●
●
●
●
●
-1-
Introduction
This meter is a compact 3 1/2-digit digital multimeter for measuring DC and AC voltage, DC and AC current, resistance, continuity, diode, and
battery. In addition, non-contact AC voltage detection, live ac wire detection and illumination functions are also provided. It features polarity
indication, data hold, full-range overload protection, and etc. It is easy to operate and is a very useful test tool.
To Next Page
Loading...