Satel MAGENTA - User Manual

MAGENTA
DIGITAL GLASS-BREAK DETECTOR
magenta_en 03/18
The MAGENTA detector enables detection of plate, tempered or laminated glass breaking.
This manual applies to the detector with electronics version 1.1 (or newer).
1. Features
 Advanced two-path sound analysis.
 Adjustable detection sensitivity.
 Supply voltage supervision.
 LED indicator.
 Tamper protection against cover removal and tearing enclosure from the wall.
2. Description
Glass-break detection
The detector will report an alarm when it detects a low frequency sound (impact) followed by
a high frequency sound (glass break) in less than 4 seconds. The alarm is signaled by the
alarm output for 2 seconds.
Supply voltage supervision
The detector will report a trouble when the supply voltage drops
below 9 V (±5%) for more than 2 seconds. The trouble results in
turning on the alarm output. The alarm output remains on as
long as the trouble exists.
Electronics board
terminal block:
+12V - power input,
COM - common ground,
TMP - tamper output (NC),
NC - alarm output (NC relay).
tamper contact.
red color LED to indicate:
 detection of low-frequency sound – ON for 0.5 seconds,
 alarm – ON for 2 seconds,
 test mode – short flash every 3 seconds,
 low supply voltage – ON.
detector configuration pins:
TEST – enabling/disabling the test mode. In the test mode,
the detector reports an alarm when it detects a high
frequency sound (glass break sound). The test mode is
enabled when the jumper is set in ON position (Fig. 2).

Satel MAGENTA Specifications

Power

supply voltage	12 V DC ±15%
standby current consumption	5 mA
maximum current consumption	10 mA

Performance

relay contacts rated load	40 mA / 16 V DC
alarm signaling time	2 s
detection range	up to 6 m

Operating Environment

environmental class according to EN50130-5	II
operating temperature range	-10 to +55 °C
enclosure dimensions	26 x 112 x 29 mm

Weight and Dimensions

weight	40 g