Need help?Do you have a question about the Satel AGATE and is the answer not in the manual?
Detects attempts to cover or paint the detector lens using infrared radiation reflection.
Signals trouble on voltage drop below 9V or signal path failure, indicated by alarm relay and steady LED.
Allows remote control of the LED indicator via a dedicated terminal connected to common ground.
Details the function of each terminal for tamper, LED, power, ground, and alarm outputs.
Explains pins for enabling/disabling LEDs via jumpers or remote control.
Describes the tamper contact activated by cover removal from the enclosure.
Identifies the microwave sensor, PIR sensor, and dual element pyrosensor components.
Explains the LED color indications for alarm, motion detection, and trouble states.
Describes potentiometers for adjusting microwave and PIR sensor sensitivity.
Points out the LEDs related to the anti-mask circuit.
Procedures for testing microwave and PIR sensors individually, detailing LED indications and jumper settings.
Power| supply voltage | 12 V DC ±15% |
|---|---|
| standby current consumption | 21 mA |
| maximum current consumption | 25 mA |
Detection and Alarm| microwave frequency | 24.125 GHz |
|---|---|
| detectable speed | 0.2-3 m/s |
| alarm signaling period | 2 s |
| warm-up period | 45 s |
Installation and Environment| recommended installation height | 2.4 m |
|---|---|
| operating temperature range | -40 to +55 °C |
| maximum humidity | 93±3% |
Weight and Dimensions| dimensions | 44 x 105 x 40 mm |
|---|---|
| weight | 92 g |
To Next Page
