Satlink WS-6979 - Page 23


5, DiSEqc1.0: Press◄► key to change the DiSEqC port.
6,DiSEqc1.1: Press◄► key to change the DiSEqC port.
7,Motor:Press◄► key to change the DiSEqC port.
IfweselectDiSEqC1.2/USALS,pressokintothemotorinterface.


○Transponder:Pressokkeytochangethecurrenttp.
○ Mode: A, Position
A1 Direction:Press◄► key to move direction to west or east.
A2 Position: set the satellite save position.
A3 Store: save the satellite position to set of A2.
○ Mode: B, Drive to Zero; move the cursor to GO, then press OK key, the motor will go to zero.
○ Mode: C, Drive to stored position; move the cursor to GO, then press OK key, the motor will go
to position of we saving in mode A Position.
○ Mode: D, Drive to Satellite; move the cursor to GO, then press OK key, the motor will go to
position of auto calculate.
D1 Direction:Press◄► key to move direction to west or east.
○ Mode: E, Set East Limit or Set west Limit, limit the motor move to east or to west.
E1 Direction:Press◄► key to move direction to west or east.
E2 Store: save the satellite position of A2
○ Mode: F, Set Limit enable or disable, set the limit enable or disable,