Satlink WS-6979 - Technical Specification; 4.1 Transmission Standards and Satellite Input


Warning:During the upgrade processing, do not power off or pull out the U
disk;otherwise will damage the machine software, can’t boot.
○ Factory Setting
Press ◄► key, then press ok key to confirm factory.
NOTE: if you set factory, alltheusersettingsandthedatabasewillbereset.
○ SYSTEM INFO
Inthesystemsetting,pressinf okeywillcheckthesystemversion.


4Technical Specification
TRANSMISSIONSTANDARDS
DVB‐S2/S,DVB‐T/T2
SATELLITEINPUT/DEMODULATION
ConnectorType FType
InputFrequency 950to2150MHz
SignalInputLevel‐65to‐25dBm
BandSwitchControl 22KHz
LNBSupply 13V/18V,IMax400mA
DemodulationType QPSK,8PSK,16APSK