Satlink WS-6935 User Manual (English)

Questions and Answers:

K
ksimpsonAug 2, 2025
Why do I get a bad picture or blocking error on my Satlink WS-6935?
- J
  Juan ChristensenAug 2, 2025
  A bad picture or blocking error on your Satlink Measuring Instruments can occur due to several reasons: * **No signal or weak signal**: Check the cable connections of the antenna and meter, and adjust the direction of the antenna. * **Satellite dish not pointing correctly**: Adjust the dish. * **Signal too strong**: Connect a signal attenuator to the antenna, or don't use an antenna. * **Antenna impedance mismatch**: Change to a matched antenna.
M
Michael LoganAug 7, 2025
What to do if there is no sound or picture on my Satlink WS-6935 Measuring Instruments?
- J
  Jessica TaylorAug 7, 2025
  If there is no sound or picture on your Satlink Measuring Instruments, it might be because the satellite dish is not pointing at the satellite. To resolve this, adjust the dish and check the signal level in the Antenna Setup Menu.
A
angela51Aug 12, 2025
What to do if the key is not working on Satlink Measuring Instruments?
- S
  Sherri OrtizAug 12, 2025
  If the key is not working on your Satlink Measuring Instruments, it could be due to the following reasons: * **Out of battery**: Even on adapter. * **Key blocks**: Make sure there are no blocks between the front panel.
L
Lori GutierrezAug 17, 2025
Why is there no display light on my Satlink Measuring Instruments?
- P
  Paul CarrilloAug 17, 2025
  If there is no display light on your Satlink Measuring Instruments, the issue could be: * The power switch is not on. Ensure the power is on, even when using an adapter. * The batteries are run out. Ensure the power is on, even when using an adapter.
R
Ronald MathisAug 22, 2025
What to do if there is no sound or picture but the front panel power light is ON on Satlink WS-6935 Measuring Instruments?
- S
  Sandra JonesAug 22, 2025
  If your Satlink Measuring Instruments has no sound or picture, but the front panel power light is ON, it might be because the AV IN jack is inserted but there is no video input. Try pulling out the AV IN cable.
C
crystal54Aug 27, 2025
How to fix AV out no picture (video) on Satlink WS-6935?
- J
  Jonathan LeonardAug 27, 2025
  If you have no picture (video) from the AV out on your Satlink Measuring Instruments, and the system is connected by SCART cable, ensure your TV is in AV mode. Additionally, check the UHF channel fixed in your system and turn the UHF properly.

Satlink WS-6935 Specifications

General

Input Level	-65 dBm to -25 dBm
Sound and Light Alarm for Locking Signal	Yes
LNB Power	13V/18V
Battery	Lithium-ion
Battery Voltage	7.4V
Operating Time	4-5 hours
Input Frequency Range	950 MHz - 2150 MHz
Input Impedance	75 Ω
Measurement Type	BER
DiSEqC	1.0, 1.1, 1.2
Satellite Database	Yes
LNB Current	400mA max